Flowserve SLC Series Interseal Manual do Utilizador Página 1

Installation InstructionsExperience In MotionInterseal SLC SeriesSelf contained single cartridge heavy duty slurry sealTM

105.9 Install bearing assembly into equipment case. Make any necessary impeller adjustments. Important: Loosen bearing assembly and drive belts only

11 Alignment Key6.2 Quench out should be connected to plant drain.6.3 Quench water must ow at all times when pump is in operation. Note: Water ow

TO REORDER REFER TOB/M #F.O.FIS125eng REV 1/13 Printed in USAflowserve.comTo find your local Flowserve representativeand find out more about Flowserve C

21 General Seal Installation InstructionsThe following instructions are designed to simplify the installation of a typical SLC Cartridge Slurry Seal

32 Equipment Preparation for Mechanical Seal Installation2.1 Follow plant safety regulations prior to equipment disassembly: • lock out motor/dr

43.8 Shaft radial run out should be less than 0.13 mm (0.005 inch) FIM (TIR). See Figure 3. Turn shaft 360° and observe the movement. Excessive mov

54.3 For adapters provided with a centering jig, simply insert the centering jig into the adapter and tighten adapter bolts, alternately adjusting th

64.7 Slide retaining bolts through the rear face of the adapter plate and screw into seal ange/gland. Evenly tighten retaining bolts to pull the sea

7 4.11 For installations with a 2 piece seal split clamp/drive collar; align the seal clamp/drive collar split lines and alignment key with the seal

5.1 Apply a light coating of O-ring lubricant to the index nger and thumb and pull seal sleeve and ange/gland O-ring element through ngers to insp

9 5.5 For adapters provided with a centering jig, simply insert the centering jig into the adapter and tighten adapter bolts, alternately adjusting t