Flowserve MW-200 Series Manual do Utilizador descarregar pdf

Installation

Instructions

Durametallic

MW-200 Series

Liquid Lubricated Dual Cartridge

Canister Seal for Mixers and Agitators

Experience In Motion

1 2 3 4 5 6 7 8

Resumo do Conteúdo

Página 1 - Instructions

Installation InstructionsDurametallic® MW-200 SeriesLiquid Lubricated Dual CartridgeCanister Seal for Mixers and AgitatorsExperience In Motion

Página 2 - 1 Equipment Check

21 Equipment Check1.1 Follow plant safety regulations prior to equipment disassembly: • Consult the plant Material Safety Data Sheet (MSDS) les for

Página 3 - Figure 1

31.10 Pressure testing of this cartridge canister dual seal prior to installation is possible using ltered dry nitrogen or instrument air. Cons

Página 4 - 2 MW-200 Seal Installation

42 MW-200 Seal InstallationTools needed: Tools provided: • Lubricant for O-rings and equipment shaft OD. Tools not provided:

Página 5 - 4 MW-200 Seal Piping

52.6 Reinstall the shaft coupling and/or drive. Remove any shaft holding or restraining clamps and complete adjustments so that the shaft is in i

Página 6 - Plan 54 - Forced Circulation

6Recommended Piping for Dual Liquid Lubricated SealsPlan 53A - Induced Circulation (high shaft speeds)Figure 2Plan 54 - Forced CirculationBufferOutlet

Página 7 - 5 Seal Operation

75 Seal OperationTo assure reliable operation of this sealing product, the following operating guidelines should be observed.5.1 Maintain the liquid

Página 8 - TO REORDER REFER TO

ﬂowserve.comTO REORDER REFER TOB/M #F.O.To ﬁnd your local Flowserve representativeand ﬁnd out more about Flowserve Corporation, visit www.ﬂowserve.com