Flowserve QX Limitorque Manual do Utilizador descarregar pdf (Página 53)

Limitorque QX Electronic Actuator FCD LMENIM3314-00 – 5/11

ﬂowserve.com

Note: The encoder rotor can only be mated to the encoder shaft in one position. The encoder shaft has 3 ﬂats that

must align correctly to the encoder rotor ID and ribs. See Figure 5.3 for reference.

Step 4

Install the three M4 screws thru encoder and standoff assembly (#17-6) and tighten. Take note not to over tighten.

Step 5

Reconnect encoder ribbon cable to motor controller board. (See section 6 for connector position on motor control

board).

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 81 82

Sem comentários

Flowserve QX Limitorque Manual do Utilizador Página 53