Flowserve QX Limitorque Manual do Utilizador descarregar pdf (Página 28)

Limitorque QX Electronic Actuator FCD LMENIM3314-00 – 5/11

Table 4.8 - Motor Cartridge Subassembly, Item 5

ITEM NUMBER DESCRIPTION QTY.

5-1 BUSHING 1

5-2 BALL BEARING 2

5-3 OIL SEAL 1

5-4 SHAFT 1

5-5 SPIRAL PIN 1

5-6 PINION, MOTOR 1

5-7 SPIRAL PIN 1

5-8 'O'-RING 1

Figure 4.9 - Motor Cartridge Subassembly, Item 5

4.3.2 Motor Cartridge Assembly Remounting.

Step 1

Lightly lubricate ‘O’-ring (#5-8). Push cartridge subassembly into housing bore assuring motor pinion (#5-6) aligns

with motor gear on handwheel side of housing. Cartridge face should be even or below the counter bore face in the

unit housing. Place bracket (#9-1) and screw (#9-2) in countered bored area with M4 tap and tighten screw. Note: The

bracket must sit ﬂat on cartridge bushing and on the housing counter bore face.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 81 82

Sem comentários

Flowserve QX Limitorque Manual do Utilizador Página 28