Flowserve SPECTORcontrol Manual do Utilizador descarregar pdf (Página 48)

Controller Menu – continued –

2-position controller setup

1. Press button 2-pos. controller in the menu Controller Setup.

2. The name of the controller is highlighted in

yellow.

3. The green input field Actual value shows

the actual value. Click in the input field to

show all established signals.

4. Select the signal that indicates the re-

quired parameters. For more information

on the setup and configuration of the

equipment see menu CAN Input and Ana-

log Input.

5. To toggle between fill and discharge con-

trol press button fill or discharge control. The selected control mode is indicated in

the right hand field.

6. The bottom field specifies the actuator. This field is highlighted in yellow if pump and/

or valve control has been adjusted.

7. To set the valve control press button Valve control.

8. To set the pump control press button Pump control.

9. To parameterise the controller press button .

2-pos. controller

Setup

Logo

Fill control

parameterisedValve control

Actual value

Controller 1

Discharge control

Pump control

Parameterised as

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 87 88

Sem comentários

Flowserve SPECTORcontrol Manual do Utilizador Página 48