Flowserve SLM-6200 Manual do Utilizador descarregar pdf (Página 10)

6.2 Remove the setting plate screws. With a screwdriver, pry the setting plates clear of

the gland and remove them. Keep the setting plates and screws with the seal at all

times. See Figure 15.

7 Barrier Fluid Piping Plans

7.1 Typical installation for a Plan 54 support system, pressurized water barrier uid

circulation by external system. See Figure 16.

See Flowserve Piping Plan Guide FTA160 or your local Flowserve representative for

best practice guidelines for installation of Plans 53A, 53B or 53C.

Note: The SLM-6200 has been designed to leak water barrier uid into the process

at 4 liters (1 gallon) per day. Barrier uid must be compatable and able to be relled

while pressurized. If another barrier uid is used leakage will increase.

Centering/Setting plate shown in

the stored position for equipment

operation.

Centering/setting plate shown in the

installed position for shipping, seal

installation and maintenance.

A screwdriver is used to lever

the centering/setting plate out.

Setting Plate Removal Figure 15

Plan 54 Figure 16

barrier inlet

barrier outlet

seal

end view

1 2 ... 5 6 7 8 9 10 11 12

Sem comentários

Flowserve SLM-6200 Manual do Utilizador Página 10