Flowserve ISC1PX Manual do Utilizador descarregar pdf (Página 4)

4 Seal Assembly Instructions

4.1 Tools Required

•

" hex key wrenches (Sizes < 2.625");

" hex key

wrenches (Sizes 2.625" and larger)

• Silicone grease (included in repair kit)

• Ethyl alcohol and clean, lint free towel for cleaning seal faces

4.2 As part of the assembly of the seal, there are several blind ts of pins and

drive ats. It may be helpful to mark the locations of the pins or drive ats

with a felt tip marker, or to align the feature with another visible feature on

the seal to assist with assembly. All seal faces should be cleaned with

alcohol prior to placing the faces together at each respective step in the

assembly process.

4.3 Arrange O-rings by dia-

metrical size. There are two

sizes: three of the largest

size (O-rings 13 , 13.1 , and

76 ), and one of the smallest

size (O-ring 19 ). Prior to

installing each O-ring at its

respective step, lightly

lubricate with silicone grease

and stretch slightly.

4.4 Place the sleeve assembly

1 on a at surface with the

drive collar end facing up.

Install the vibration dampener

183 into sleeve end housing.

Place the rotating face O-ring

76 in sleeve O-ring groove

behind surface with drive ats

in sleeve. Install sleeve

gasket O-ring in groove in ID

of sleeve. (Figure 5)

4.5 Align the two ats on the

rotating face 15 with the

two ats on the inside of

the seal drive 2 and press

the rotating face into place

using nger pressure only.

(Figure 6)

Figure 5

Figure 6

Sleeve

Gasket

O-ring

Rotating Face

Gasket 76

Vibration

Dampner

183

Rotating

Face

Drive

Flats

Seal

Drive

1 2 3 4 5 6 7 8

Comentários a estes Manuais

Sem comentários

Flowserve ISC1PX Manual do Utilizador Página 4

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Flowserve ISC1PX