Flowserve SoftTools Suite 7.0 Manual do Utilizador descarregar pdf (Página 4)

VLAUG001-00 ©Flowserve Corporation, Valtek Control Products, Tel. USA 801 489 8611 4 of 21

Chapter 2: Software Installation

System Requirements

The following hardware is required to use SoftTools:

1. A computer using a Pentium, higher, or compatible processor and running

Windows 95, 98, NT, 2000, or XP.

2. CD-ROM drive

3. Mouse or other cursor-pointing device.

4. Memory requirements of 32MB RAM minimum, with 64MB RAM

recommended.

5. Approximately 30MB disk space for installation.

6. Serial communication ports: 1 minimum available with 8 maximum possible.

Installing SoftTools 7.0

1. You must be an administrator on the system. If you do not have administrative

rights, have your system administrator install and run SoftTools one time.

2. Insert the SoftTools 7.0 program CD into the computer CD-ROM drive.

3. Click the Start button on the task bar.

4. Select Run. Type e:\ SoftTools 7 Setup.exe (to install from the E: drive) into the

Run edit box; then click on the OK button.

Application Installation

1. At the Welcome message dialog, click on the Next button.

2. At the Choose Destination Location dialog, the user may accept the default

directory from the dialog box or click on the Browse button to select an

alternate destination folder. After selecting or editing a directory, click on the

Next button.

3. At the Select Program Manager Group, click Next.

4. At the Start Installation dialog, click Next. If a previous installation is

detected, click Yes to preserve data from an earlier version of SoftTools.

Click No to continue without saving previous data.

5. Click Finish to complete the installation.

1 2 3 4 5 6 7 8 9 ... 20 21

Sem comentários

Flowserve SoftTools Suite 7.0 Manual do Utilizador Página 4