Flowserve Circpac MD Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Hardware Flowserve Circpac MD. Flowserve Circpac MD User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 8
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
Installation
Instructions
Experience In Motion
Circpac MD
Split Segmented
Circumferential Gas Seal
Vista de página 0
1 2 3 4 5 6 7 8

Resumo do Conteúdo

Página 1 - Instructions

Installation InstructionsExperience In MotionCircpac MDSplit Segmented Circumferential Gas Seal

Página 2

1 Equipment Check and Seal Preparation1.1 Refer to Figure 1 for sleeve/shaft and equipment requirements.1.2 The equipment sleeve/shaft must be clea

Página 3 - Figure 5

32 Seal Installation (Split Housing Designs)Seal components are assembled in the following order: housing gasket (if separate), bottom housing half,

Página 4 - Figure 8

4Figure 62.5 Select a ring segment that does not havethedrivepin.Positionitoverthegroove in the lower housing half. Make sure the numbered si

Página 5 - Figure 9

52.9 Rotate the ring assembly until the drive pin engages the pin slot at the housing joint. 2.10 Repeat steps 2.3-2.9 with all segmented rings. Fi

Página 6 - Figure 13

62.13 Center the housing assembly on the shaft as required. If centering devices are used, release any housing supports so that the centering devices

Página 7 - 5 Repairs

7 3 Seal Installation (Non-split Housing Designs) 3.1 Circpac MD seals with non-split housings are pre-assembled at the factory for cartridge inst

Página 8 - TO REORDER REFER TO

TO REORDER REFER TOB/M #F.O.FIS153eng REV 01/03 Printed in USAflowserve.comTo find your local Flowserve representativeand find out more about Flowserve C

Comentários a estes Manuais

Sem comentários