Flowserve UBK 46 Manual do Utilizador descarregar pdf (Página 14)

Attention

■

Only qualified welders certified e. g. according to DIN EN 287 may weld the

steam trap into pressurized lines.

■

Do not insulate trap.

Installation – continued –

Heat treatment of welds

A subsequent heat treatment of the welds is not required.

The flanged connections of the UBK 46 must be permanently bolted, ensuring tight shut-off. If

necessary raise or lower the condensate discharge temperature. For more information refer to section

“Adjust discharge temperature” on the following page.

UBK 46

Commissioning

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Sem comentários

Flowserve UBK 46 Manual do Utilizador Página 14